Triggers
R&S
®
RTE
263User Manual 1326.1032.02 ─ 20
This setting is available for user-defined video signals if "Standard" is set to "Custom".
Remote command:
TRIGger<m>:TV:CUSTom:LDURation on page 1196
Pulse width
Sets the width of the sync pulse.
This setting is available for user-defined video signals if "Standard" is set to "Custom".
Remote command:
TRIGger<m>:TV:CUSTom:SDURation on page 1196
Scan
Sets the scanning system.
This setting is available for user-defined video signals if "Standard" is set to "Custom".
"Interlaced"
Interlace scanning uses two fields to create a frame. One field con-
tains all the odd lines (odd, first, or upper filed), the other contains all
the even lines of the image (even, second, or lower field). First the
lines of the odd filed are processed, then the lines of the even field.
"Progressive"
Progressive scanning is a method to capture, transmit and display all
lines of a frame in sequence.
"Segmented"
Progressive segmented frame uses progressive scanning to capture
the frame, and interlaced scanning for transmission and display.
Remote command:
TRIGger<m>:TV:CUSTom:SCANmode on page 1195
6.3.15 Line trigger
Access: [TRIGGER] > "Setup" tab > "Source" = "Line"
The line trigger triggers on the AC power input and synchronizes the signal to the AC
power frequency. It is not a trigger type but rather a special trigger source. Use the line
Trigger types
To Next Page
Loading...
