Protocol analysis
R&S
®
RTE
793User Manual 1326.1032.02 ─ 20
"Condition"
Defining a specific index or an index range requires to set the opera-
tor to one of the following conditions: equal, in range.
"Min"
Specifies the index or sets the start value of an index range.
"Max"
Sets the end value of an index range, if "Condition" is set to "In
range".
Remote command:
TRIGger<m>:CMSB:ADVanced:IMAX on page 1753
TRIGger<m>:CMSB:ADVanced:FRAMe<n>:FLD<o>:IMAX on page 1753
TRIGger<m>:CMSB:ADVanced:IMIN on page 1753
TRIGger<m>:CMSB:ADVanced:FRAMe<n>:FLD<o>:IMIN on page 1753
TRIGger<m>:CMSB:ADVanced:IOPerator on page 1753
TRIGger<m>:CMSB:ADVanced:FRAMe<n>:FLD<o>:IOPerator on page 1753
13.14.3.2 Triggering on custom Manchester / NRZ serial bus
Prerequisite: A bus is configured for the custom serial bus signal to be analyzed.
For the basic trigger settings, proceed in the following way:
1. Press the [PROTOCOL] key and select the "Trigger" tab.
2. Press the "Select" button. The "Source" button is shown.
3. Tap the "Source" button and select the "Serial bus" trigger source.
4. Select the serial bus that is set to Custom.
5. Tap "Type" and select the trigger type to be used for custom serial bus protocol
analysis.
6. Depending on the selected custom serial bus coding standard, more setup condi-
tions have to be specified.
For information on how to proceed with the configuration settings, see Chap-
ter 13.14.3.1, "Custom: Manchester / NRZ trigger settings", on page 788.
13.14.4 Custom filter
With the filter function you can display only selected events in the acquired data. Only
one single filter can be enabled on the protocol at a time.
13.14.4.1 Custom filter settings
Access: [PROTOCOL] > "Protocol = Custom" > "Filter" tab
Filter
Enables filtering on a custom serial bus.
Remote command:
BUS<m>:CMSB:FILTer:ENABle on page 1756
Custom: Manchester / NRZ (option R&S
RTE-K50)M
To Next Page
Loading...
