Rohde & Schwarz RTE - Configuration; USBPD (Option R&S RTE-K63)

Remote control commands
R&S
®
RTE
1831User Manual 1326.1032.02 ─ 20
Return values:
<Stop> Range: -100E+24 to 100E+24
Increment: 100E-12
*RST: 0
Default unit: s
Usage: Query only
SEARch:RESult:USB:PCOunt? <SearchName>
Returns the search result's packet count, i.e. the number of packets found in the
search result.
Query parameters:
<SearchName>
Return values:
<Count> Range: 0 to 100000
Increment: 1
*RST: 0
Usage: Query only
18.17.18 USBPD (option R&S RTE-K63)
● Configuration.......................................................................................................1831
● Trigger.................................................................................................................1833
● Decode results.................................................................................................... 1839
● Search settings................................................................................................... 1844
● Search results..................................................................................................... 1850
18.17.18.1 Configuration
In all BUS<m>:USBPd commands, the suffix <m> selects the serial bus.
BUS<m>:USBPd:DETail............................................................................................... 1831
BUS<m>:USBPd:HYSTeresis........................................................................................1832
BUS<m>:USBPd:SOURce............................................................................................1832
BUS<m>:USBPd:THReshold........................................................................................ 1832
BUS<m>:USBPd:THRBottom........................................................................................1832
BUS<m>:USBPd:THRMid.............................................................................................1833
BUS<m>:USBPd:THRTop.............................................................................................1833
BUS<m>:USBPd:DETail <Detail>
If enabled, the data words are broken down into subframes. If not enabled the data
words are displayed as 32-bit data words.
Suffix:
<m>
.
1..4
Protocols