Rohde & Schwarz RTE - Settings for XY-Diagrams; XY-Diagram

Waveform analysis
R&S
®
RTE
318User Manual 1326.1032.02 ─ 20
b) Enter the number of the required acquisition in "Acq index". The newest acqui-
sition in the memory always has the index "0". Older acquisition have a nega-
tive index.
c) Tap "Save" or "Save As" to save the waveform data to the specified file.
9. To save several subsequent history waveforms:
a) Enable "Multiple Wfms".
b) Define the range of the waveforms to be saved with "Start acq" and "Stop acq".
c) Tap "Start Export" to play the history and to save the history data to the speci-
fied file.
Se also Chapter 12.2.2, "Waveforms - export settings", on page 485.
7.5 XY-diagram
XY-diagrams combine the voltage levels of two waveforms in one diagram. They use
the voltage level of a second waveform as the x-axis, rather than a time base. This
allows you to perform phase shift measurements, for example. You can display up to
four different XY-diagrams.
XY-diagrams can be used to display the IQ representation of a signal.
7.5.1 Settings for XY-diagrams
Access: "Display" > "XY-Diagram" tab
You can display up to four different XY-diagrams that use the voltage level of a wave-
form as the x-axis, rather than a time base.
Make sure to select the tab of the required XY-diagram.
XY-diagram