Rohde & Schwarz RTE - Dynamic on Resistance

Remote control commands
R&S
®
RTE
1959User Manual 1326.1032.02 ─ 20
●
RMS: RMS value of the long-term measurement results
●
STDDev: standard deviation of the long-term measurement results
Query parameters:
<MeasType> FREQ | DUTY
Usage: Query only
POWer:MODulation:SOURce <Source>
Selects the source for the measurement.
Parameters:
<Source> CURRENT | VOLTAGE
*RST: VOLTAGE
POWer:MODulation:TYPE <AnalysisType>
Sets the type of measurement.
Parameters:
<AnalysisType> TURNON | CONT
*RST: CONT
18.20.8 Dynamic ON resistance
POWer:DONRes:AUTO................................................................................................1959
POWer:DONRes:AVG.................................................................................................. 1959
POWer:DONRes:EXECute............................................................................................1960
POWer:DONRes:GATE<m>:STARt................................................................................1960
POWer:DONRes:GATE<m>:STOP................................................................................ 1960
POWer:DONRes:REPort:ADD.......................................................................................1960
POWer:DONRes:RESult:RESistance?........................................................................... 1960
POWer:DONRes:AUTO <Autoscale>
Selects the scaling for the display of the results.
Parameters:
<Autoscale> AUTO | MANUAL
*RST: MANUAL
POWer:DONRes:AVG <Average>
Enables/disables averaging.
Parameters:
<Average> ON | OFF
*RST: ON
Power analysis (option R&S RTE-K31)