Data and file management
R&S
®
RTE
485User Manual 1326.1032.02 ─ 20
File size = Number of samples / 8
For example, 100 MSa are written into a 12.5 MByte BIN file. After reading the file, you
have to extract the samples from the data words.
12.2.2 Waveforms - export settings
Access: [FILE] > "Waveform"
In this tab, the storage settings for waveform data are defined.
See also: Chapter 12.2.7, "Saving and loading waveform data", on page 496.
Source
Selects the waveform to be exported if "Multichannel export" is disabled.
Active waveforms of input channels, math signals and reference waveforms are availa-
ble for export.
If the MSO option R&S RTE-B1 is installed, you can save also digital channels and
parallel buses.
Remote command:
EXPort:WAVeform:SOURce on page 1400
Multi-channel export
Enables or disables the export of multiple input channels. If enabled, you can export
the data of selected input channels (Selected sources) into one file.
If disabled, you can export one "Source" on page 485 waveform.
Waveform data and results
To Next Page
Loading...
