Waveform analysis
R&S
®
RTE
280User Manual 1326.1032.02 ─ 20
7.1.2 Zoom settings
The zoom area, i.e. the section to be enlarged, can be defined using two different
methods:
●
Using the zoom functions on the toolbar and draw the zoom area on the touch-
screen
●
Specifying numeric values:
– start and stop values for the x- and y-axes
– x and y position of one point in the diagram plus a range for the x- and y-axes
See also: Chapter 7.1.1, "Methods of zooming", on page 278.
● Zoom functions on the toolbar...............................................................................280
● Start and stop settings.......................................................................................... 281
● Position and range settings...................................................................................282
7.1.2.1 Zoom functions on the toolbar
The zoom icon on the toolbar shows the last selected zoom type. A short tap on the
icon activates the selected zoom. If you touch the icon and drag your finger down, a
menu opens where you can select another zoom type.
Standard zoom
Displays a magnified section of the diagram in an additional zoom diagram. It is a dis-
play zoom, instrument settings are not changed.
Touch and hold the zoom area to open the "Zoom" dialog box.
Remote command:
LAYout:ZOOM:ADD on page 1212
Hardware zoom
Changes the instrument settings - horizontal and vertical scales as well as trigger level
and offset - to display a part of the diagram in greater detail.
Coupled zoom
Creates a coupled zoom area and its related zoom diagram. If you change the size of
one zoom area, the size of all coupled zoom areas is changed as well.
Remote command:
LAYout:ZOOM:ADDCoupled on page 1212
Fingertip zoom
Magnifies the waveforms around your fingertip.
Tap the icon and put your finger on the waveform. The touched part of the waveform is
displayed in a magnifier. Drag your finger on the screen to move the magnifier. You can
change the zoom factor using the [Navigation] knob.
Zoom
To Next Page
Loading...
