Instrument setup
R&S
®
RTE
145User Manual 1326.1032.02 ─ 20
Remote command:
DISPlay:PERSistence:TIME on page 1090
Reset
Resets the display, removing persistent all waveform points.
Remote command:
DISPlay:PERSistence:RESet on page 1091
Intensity
This value determines the strength of the waveform line in the diagram. Enter a per-
centage between 0 (not visible) and 100% (strong). The default value is 50%.
You can also use the [INTENSITY] knob on the left side of the screen to adjust the
waveform intensity directly.
Note: Use of color tables. The exact mapping of the cumulative value occurrences
according to the assigned color table is guaranteed only if the intensity is set to 50%.
All other intensity values falsify the mapping but can improve the visibility of the signal.
See also: Chapter 4.4.3.2, "Changing waveform colors", on page 153.
Remote command:
DISPlay:INTensity on page 1091
Style
Select the style in which the waveform is displayed:
"Vectors"
The individual waveform points are connected by a line.
Define the strength of the line using the [INTENSITY] knob.
"Dots"
Only the individual waveform points are displayed. Waveform sample
points are the ADC sample points and additional interpolated points if
"Interpolated time" is used for resolution enhancement. To see the
dots of one waveform, perform one acquisition with [RUN N×
SINGLE] and N=1 ("Average count" = 1). During continuous acquisi-
tion, or a [RUN N× SINGLE] acquisition with N > 1, the dots of multi-
ple subsequent waveforms are displayed on the screen, and the
waveform looks like a line.
Remote command:
DISPlay:DIAGram:STYLe on page 1091
Color
Shows the current color of the selected waveform. To change the color, tap the button
and select a color. The color of the waveform, its signal icon, channel icon, and of the
illuminated keys is adjusted to the new color.
Remote command:
DISPlay:COLor:SIGNal<m>:COLor on page 1091
Set to default color
Resets the color of the selected waveform to the factory default.
Use color table
If enabled, the selected waveform is displayed according to its assigned color table.
Display configuration
To Next Page
Loading...
