Rohde & Schwarz RTE - Page 1213

Remote control commands
R&S
®
RTE
1213User Manual 1326.1032.02 ─ 20
LAYout:ZOOM:ONEDiagram <ShowInOne>
Shows all zooms of a diagram in one zoom window. The zoomed areas are overlaid for
better comparison of the zoomed waveforms.
The command takes effect on all zoom diagrams.
Parameters:
<ShowInOne> ON | OFF
*RST: OFF
Usage: Asynchronous command
LAYout:ZOOM:POSCoupling
<DiagramName>, <ZoomName>, <PositionCoupl>
LAYout:ZOOM:POSCoupling? <DiagramName>, <ZoomName>
Enables or disables the position coupling of coupled zooms. If position coupling is
enabled and one zoom area is moved, the other coupled zoom areas are moved, too,
and keep their distance.
Parameters:
<PositionCoupl> ON | OFF
*RST: OFF
Parameters for setting and query:
<DiagramName> String with the name of the diagram on which the zoom is based
<ZoomName> String with the name of the zoom diagram
Usage: Asynchronous command
LAYout:ZOOM:HORZ:MODE <DiagramName>, <ZoomName>,<Mode>
LAYout:ZOOM:HORZ:MODE? <DiagramName>, <ZoomName>
Defines whether absolute or relative values are used to specify the x-axis values.
Since the zoom area refers to the active signal, relative values ensure that the zoom
area remains the same.
Parameters:
<Mode> ABS | REL
Mode used to specify the x-axis values of the zoom area.
*RST: ABS
Parameters for setting and query:
<DiagramName> Name of the diagram on which the zoom area is based.
<ZoomName> Name of the zoom diagram
Example: See Chapter 18.3.1.2, "Creating zoom diagrams", on page 1056
Usage: Asynchronous command
Waveform analysis