Rohde & Schwarz RTE - Page 1666

Remote control commands
R&S
®
RTE
1666User Manual 1326.1032.02 ─ 20
SEARch:TRIGger:ETHernet:FRAMe:CCONdition <SearchName>,<CRCOperator>
SEARch:TRIGger:ETHernet:FRAMe:CCONdition? <SearchName>
Defines the operator to search for a Cyclic Redundancy Code (CRC, or frame check)
error condition within a frame.
Parameters:
<CRCOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less than or equal, Greater Than,
Greater than or equal. These conditions require a CRC pattern
to be set with SEARch:TRIGger:ETHernet:FRAMe:CMIN.
INRange | OORange
In range, Out of range. Set the minimum and maximum value of
the range with SEARch:TRIGger:ETHernet:FRAMe:CMIN
and SEARch:TRIGger:ETHernet:FRAMe:CMAX.
*RST: EQUal
Parameters for setting and query:
<SearchName> String parameter
SEARch:TRIGger:ETHernet:FRAMe:CMIN <SearchName>,<CRCPatternMin>
SEARch:TRIGger:ETHernet:FRAMe:CMIN? <SearchName>
Defines a CRC error condition pattern, or sets the start value of such a pattern.
Parameters:
<CRCPatternMin> Numeric or string pattern, see Chapter 18.4.6, "Bit pattern
parameter", on page 1076. The string parameter accepts the bit
value X (don't care).
Parameters for setting and query:
<SearchName> String parameter
SEARch:TRIGger:ETHernet:FRAMe:CMAX <SearchName>,<CRCPatternMax>
SEARch:TRIGger:ETHernet:FRAMe:CMAX? <SearchName>
Sets the end value of a CRC error condition pattern, if SEARch:TRIGger:ETHernet:
FRAMe:CCONdition is set to INRange or OORange.
Parameters:
<CRCPatternMax> Numeric or string pattern, see Chapter 18.4.6, "Bit pattern
parameter", on page 1076. The string parameter accepts the bit
value X (don't care).
Parameters for setting and query:
<SearchName> String parameter
Protocols