Rohde & Schwarz RTE - Page 708

Protocol analysis
R&S
®
RTE
708User Manual 1326.1032.02 ─ 20
Type
Define the event types to be searched. Available event types are "Frame" and "Error".
Remote command:
SEARch:TRIGger:ETHernet:FRAMe:SELect on page 1662
SEARch:TRIGger:ETHernet:ERRor:SELect on page 1667
Frame
Searches for the following frame conditions: "Destination address", "Source address",
"Length/Type", or "Frame check".
Destination address ← Frame
To search for a destination address, an address pattern or optionally an address range
have to be specified.
Remote command:
SEARch:TRIGger:ETHernet:FRAMe:DCONdition on page 1663
SEARch:TRIGger:ETHernet:FRAMe:DMIN on page 1663
SEARch:TRIGger:ETHernet:FRAMe:DMAX on page 1663
Source address ← Frame
To search for a source address, an address pattern or optionally an address range
have to be specified.
Remote command:
SEARch:TRIGger:ETHernet:FRAMe:SCONdition on page 1664
SEARch:TRIGger:ETHernet:FRAMe:SMIN on page 1664
SEARch:TRIGger:ETHernet:FRAMe:SMAX on page 1664
Length/Type ← Frame
To search for a frame length or frame type, a type/length pattern or optionally a range
of type/length patterns have to be specified.
Remote command:
SEARch:TRIGger:ETHernet:FRAMe:TCONdition on page 1665
SEARch:TRIGger:ETHernet:FRAMe:TMIN on page 1665
SEARch:TRIGger:ETHernet:FRAMe:TMAX on page 1665
Frame check ← Frame
To search for a specific pattern, this pattern or optionally a range of patterns have to be
specified.
Ethernet 10BASE-T and 100BASE-TX (option R&S
RTE-K8)