Rohde & Schwarz RTE - Page 814

Protocol analysis
R&S
®
RTE
814User Manual 1326.1032.02 ─ 20
Available event types are "Frame Start", "Frame Stop", and "Data".
Only if search criteria type "Data" is selected, individual search parameters can be
specified in the tabs below the "Search criteria" dialog. For these parameters, see "ST"
on page 814, "OP" on page 814, "PHYAD/PRTAD" on page 814, "REGAD/DEVAD"
on page 814, and "DATA/ADDRESS" on page 814.
Remote command:
SEARch:TRIGger:MDIO:TYPE on page 1786
ST
Selects the start of frame code of the frame pattern; available only in search criteria
type "Data". Permissible frame patterns are: Clause 22, Clause 45, or Any
Remote command:
SEARch:TRIGger:MDIO:ST on page 1786
OP
Selects the Type of Frame code (or OP code, OpCode, operation code); available only
in search criteria type "Data". Available frame types are: Address, Write, Read, Post
Read, or Any
Remote command:
SEARch:TRIGger:MDIO:FRAMetype on page 1785
PHYAD/PRTAD
Sets the physical address or port address (5 bits) of the frame pattern; available only in
search criteria type "Data".
Remote command:
SEARch:TRIGger:MDIO:PHYS on page 1786
REGAD/DEVAD
Sets the register address or device address (5 bits) of the frame pattern; available only
in search criteria type "Data".
Remote command:
SEARch:TRIGger:MDIO:REGI on page 1786
DATA/ADDRESS
Defines the payload data pattern or address pattern (16 bits); available only in search
criteria type "Data".
MDIO (option R&S
RTE-K55)