Rohde & Schwarz RTE - Page 1786

Remote control commands
R&S
®
RTE
1786User Manual 1326.1032.02 ─ 20
SEARch:TRIGger:MDIO:PHYS <SearchName>,<PhyAddr>
SEARch:TRIGger:MDIO:PHYS? <SearchName>
Allows to set the physical address (in Clause 22) or port address (in Clause 45) of the
frame pattern (5 bits); available only in search criteria type "Data".
Parameters:
<PhyAddr>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:MDIO:REGI <SearchName>,<RegAddr>
SEARch:TRIGger:MDIO:REGI? <SearchName>
Allows to set the register address (in Clause 22) or device address (in Clause 45) of
the frame pattern (5 bits); available only in search criteria type "Data".
Parameters:
<RegAddr>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:MDIO:ST <SearchName>,<StartCode>
SEARch:TRIGger:MDIO:ST? <SearchName>
Allows to select the start of frame code of the frame pattern; available only in search
criteria type "Data".
Parameters:
<StartCode> ST00 | ST01 | ST0X
ST00
Clause 45
ST01
Clause 22
ST0X
Any permissible start pattern
*RST: ST0X
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:MDIO:TYPE <SearchName>,<Type>
SEARch:TRIGger:MDIO:TYPE? <SearchName>
Selects the event type to search for.
Parameters:
<Type> STARt | STOP | DATA
Protocols