Rohde & Schwarz RTE - Page 1605

Remote control commands
R&S
®
RTE
1605User Manual 1326.1032.02 ─ 20
BUS<m>:I2S:TRACk:LEFT <Left>
BUS<m>:I2S:TRACk:RIGHt <Right>
Enables or disables the track of the indicated channel. The commands are relevant for
I²S standard, left-justified and right-justified audio data formats.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<Left>, <Right> ON | OFF
*RST: OFF
BUS<m>:I2S:TRACk:TD1Ch
<TDMCh1>
BUS<m>:I2S:TRACk:TD2Ch <TDMCh2>
BUS<m>:I2S:TRACk:TD3Ch <TDMCh3>
BUS<m>:I2S:TRACk:TD4Ch <TDMCh4>
BUS<m>:I2S:TRACk:TD5Ch <TDMCh5>
BUS<m>:I2S:TRACk:TD6Ch <TDMCh6>
BUS<m>:I2S:TRACk:TD7Ch <TDMCh7>
BUS<m>:I2S:TRACk:TD8Ch <TDMCh8>
Enables or disables the track of the indicated channel. The commands are relevant for
TDM audio data.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<TDMChX> ON | OFF
*RST: OFF
MEASurement<m>:TRACk[:STATe] <State>
Enables the track functionality and displays the track.
The track functionality requires at least one option, see "Enable (Track)" on page 389.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
Protocols