Rohde & Schwarz RTE - Page 1877

Remote control commands
R&S
®
RTE
1877User Manual 1326.1032.02 ─ 20
TRIGger<m>:CXPI:DATA:IMAX.....................................................................................1879
TRIGger<m>:CXPI:DATA:IMIN...................................................................................... 1879
TRIGger<m>:CXPI:DEXTension:CONDition....................................................................1879
TRIGger<m>:CXPI:DEXTension:MAX............................................................................ 1880
TRIGger<m>:CXPI:DEXTension:MIN............................................................................. 1880
TRIGger<m>:CXPI:DLC:CONDition............................................................................... 1880
TRIGger<m>:CXPI:DLC:MAX........................................................................................1880
TRIGger<m>:CXPI:DLC:MIN.........................................................................................1881
TRIGger<m>:CXPI:ERRor:CRC.................................................................................... 1881
TRIGger<m>:CXPI:ERRor:DLC.....................................................................................1881
TRIGger<m>:CXPI:ERRor:IBS...................................................................................... 1881
TRIGger<m>:CXPI:ERRor:IFS...................................................................................... 1882
TRIGger<m>:CXPI:ERRor:LENGth................................................................................1882
TRIGger<m>:CXPI:ERRor:PARity..................................................................................1882
TRIGger<m>:CXPI:ERRor:UART...................................................................................1882
TRIGger<m>:CXPI:FID:CONDition................................................................................ 1883
TRIGger<m>:CXPI:FID:MAX.........................................................................................1883
TRIGger<m>:CXPI:FID:MIN..........................................................................................1883
TRIGger<m>:CXPI:NM.................................................................................................1883
TRIGger<m>:CXPI:TYPE..............................................................................................1884
TRIGger<m>:CXPI:CT <CT>
Sets the value of the counter (CT), 2 bits indicating the continuity of the frame.
Suffix:
<m>
.
1..3
Parameters:
<CT>
TRIGger<m>:CXPI:DATA:DCONdition <DataOperator>
Sets the condition for the data pattern. You can define no value, an exact value or a
value range.
Suffix:
<m>
.
1..3
Parameters:
<DataOperator> OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
OFF = ANY
Any data pattern is considered
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding TRIGger<m>:CXPI:DATA:
DMIN command.
Protocols