Rohde & Schwarz RTE - Page 1879

Remote control commands
R&S
®
RTE
1879User Manual 1326.1032.02 ─ 20
TRIGger<m>:CXPI:DATA:IMAX <DataIndexMax>
Sets the end value of a data index range if TRIGger<m>:CXPI:DATA:ICONdition
is set to INRange or RANge.
Suffix:
<m>
.
1..3
Parameters:
<DataIndexMax> Range: 1 to 0
Increment: 1
*RST: 0
TRIGger<m>:CXPI:DATA:IMIN
<DataIndexMin>
Specifies a data index bit pattern, or sets the start value of a pattern range.
Suffix:
<m>
.
1..3
Parameters:
<DataIndexMin> Range: 1 to 0
Increment: 1
*RST: 1
TRIGger<m>:CXPI:DEXTension:CONDition <DLCEXTOperator>
Set the condition for the DLC extend value. You can define an exact value or a value
range.
Suffix:
<m>
.
1..3
Parameters:
<DLCEXTOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding TRIGger<m>:CXPI:
DEXTension:MIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:CXPI:DEXTension:MIN and
TRIGger<m>:CXPI:DEXTension:MAX.
*RST:
EQUal
Protocols