Rohde & Schwarz RTE - Page 1880

Remote control commands
R&S
®
RTE
1880User Manual 1326.1032.02 ─ 20
TRIGger<m>:CXPI:DEXTension:MAX <DLCEXTMax>
Sets the end value of a DLC extend range if TRIGger<m>:CXPI:DEXTension:
CONDition is set to INRange or OORange.
Suffix:
<m>
.
1..3
Parameters:
<DLCEXTMax>
TRIGger<m>:CXPI:DEXTension:MIN
<DLCEXTMin>
Specifies a data extension bit pattern, or sets the start value of a pattern range.
Suffix:
<m>
.
1..3
Parameters:
<DLCEXTMin>
TRIGger<m>:CXPI:DLC:CONDition <DLCOperator>
Set the condition for the DLC. You can define an exact value or a value range.
Suffix:
<m>
.
1..3
Parameters:
<DLCOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one DLC pattern
to be set with the corresponding TRIGger<m>:CXPI:DLC:MIN
command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:CXPI:DLC:MIN and
TRIGger<m>:CXPI:DLC:MAX.
*RST:
EQUal
TRIGger<m>:CXPI:DLC:MAX <DLCMax>
Sets the end value of a data type range if TRIGger<m>:CXPI:DLC:CONDition is set
to INRange or OORange.
Suffix:
<m>
.
1..3
Protocols