Rohde & Schwarz RTE - Page 1884

Remote control commands
R&S
®
RTE
1884User Manual 1326.1032.02 ─ 20
TRIGger<m>:CXPI:TYPE <Type>
Selects the trigger type for the CXPI analysis.
Suffix:
<m>
.
1..3
Parameters:
<Type> STARt | NORMal | NPOLl | SLEEP | LONG | LPOLl | PID |
PTYPe | PTPD | ERRor
STARt
Triggers on the STARt of the frame.
NORMal
Triggers on a NORMal frame. Optionally you can define a frame
ID condition, an NM, a CT, a DLC condition, a data pattern con-
dition and an index condition.
NPOLl
Triggers on a Normal POLL frame. Optionally you can define a
frame ID condition, an NM, a CT, a DLC condition, a data pattern
condition and an index condition.
SLEEP
Triggers on a SLEEP frame. Optionally you can define an NM, a
CT, a data pattern condition and an index condition.
LONG
Triggers on a Long frame. Optionally you can define a frame ID
condition, an NM, a CT, a DLC extend condition, a data pattern
condition and an index condition.
LPOLl
Triggers on a Long POLL frame.
PID
Triggers on a Protected ID field. Optionally, you can define the
frame ID pattern.
PTYPe
Triggers on a Protected TYPE field.
PTPID
Triggers on a Protected Type field followed by a PID field.
Optionally, you can define the frame ID pattern.
ERRor
Trigger on selected error types. Define the error types with:
TRIGger<m>:CXPI:ERRor:CRC
TRIGger<m>:CXPI:ERRor:DLC
TRIGger<m>:CXPI:ERRor:IBS
TRIGger<m>:CXPI:ERRor:IFS
TRIGger<m>:CXPI:ERRor:LENGth
TRIGger<m>:CXPI:ERRor:PARity
TRIGger<m>:CXPI:ERRor:UART
*RST:
STARt
Protocols