Rohde & Schwarz RTE

To Next Page

To Previous Page

Remote control commands

R&S

RTE

1278User Manual 1326.1032.02 ─ 20

LAYout:HISTogram:VERTical:RELative:STOP................................................................. 1282

LAYout:HISTogram:RESet.............................................................................................1282

LAYout:HISTogram:REMove..........................................................................................1282

LAYout:HISTogram:ADD <HistogramName>, <Source>, <XStart>, <XStop>,

Defines and displays a new histogram for the specified source.

Note: To define the mode of the histogram (vertical or horizontal), use the LAYout:

HISTogram:MODE command.

For numerical values, the input of a unit is not supported for this command.

Setting parameters:

<HistogramName> String defining the histogram name which is used to refer to the

histogram by other functions.

<Source> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |

M7 | M8 | R1 | R2 | R3 | R4 | MRESult1 | MRESult2 | MRESult3 |

SG7TL2 | SG8TL1 | SG8TL2 | Z1V1 | Z1V2 | Z1V3 | Z1V4 |

Z1I1 | Z1I2 | Z1I3 | Z1I4 | Z2V1 | Z2V2 | Z2V3 | Z2V4 | Z2I1 |

Z2I2 | Z2I3 | Z2I4 | DIFF1 | DIFF2 | COMMON1 | COMMON2

Data source of the histogram, see Chapter 18.4.2, "Waveform

parameter", on page 1074

<XStart> Defines the start value of the x-value range.

<XStop> Defines the stop value of the x-value range.

<YStart> Defines the start value of the y-value range.

<YStop> Defines the stop value of the y-value range.

<Relative> ON | OFF

Defines whether relative or absolute values are used for the

value range definition.

<Orientation> VERTical | HORizontal

Example: See "Creating and reading histograms" on page 1058

Usage: Setting only

Asynchronous command

LAYout:HISTogram:SOURce <HistogramName>,<Source>

LAYout:HISTogram:SOURce? <HistogramName>

Defines the waveform which is the source of the histogram.

Automatic measurements

Rohde & Schwarz RTE - Page 1278