Rohde & Schwarz RTE - Page 1279

Remote control commands
R&S
®
RTE
1279User Manual 1326.1032.02 ─ 20
Parameters:
<Source> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4 | MRESult1 | MRESult2 | MRESult3 |
MRESult4 | MRESult5 | MRESult6 | MRESult7 | MRESult8 |
SG1TL1 | SG1TL2 | SG2TL1 | SG2TL2 | SG3TL1 | SG3TL2 |
SG4TL1 | SG4TL2 | SG5TL2 | SG6TL1 | SG6TL2 | SG7TL1 |
SG7TL2 | SG8TL1 | SG8TL2 | Z1V1 | Z1V2 | Z1V3 | Z1V4 |
Z1I1 | Z1I2 | Z1I3 | Z1I4 | Z2V1 | Z2V2 | Z2V3 | Z2V4 | Z2I1 |
Z2I2 | Z2I3 | Z2I4 | DIFF1 | DIFF2 | COMMON1 | COMMON2
Waveform source of the histogram, see Chapter 18.4.2, "Wave-
form parameter", on page 1074.
Parameters for setting and query:
<HistogramName> String parameter
Usage: Asynchronous command
LAYout:HISTogram:MODE
<HistogramName>,<Mode>
LAYout:HISTogram:MODE? <HistogramName>
Defines or queries the type of histogram.
Parameters:
<Mode> VERTical | HORizontal
VERTical
Amplitude histogram (horizontal bars across amplitude)
HORizontal
Time or frequency histogram (vertical bars over time/frequen-
cies)
*RST: VERTical
Parameters for setting and query:
<HistogramName> The name of the histogram as defined using LAYout:
HISTogram:ADD on page 1278.
Usage: Asynchronous command
LAYout:HISTogram:HORZ:MODE <HistogramName>,<Mode>
LAYout:HISTogram:HORZ:MODE? <HistogramName>
Defines or queries whether the value range limits are entered as absolute or relative
values.
Parameters:
<Mode> ABS | REL
*RST: ABS
Parameters for setting and query:
<HistogramName>
Usage: Asynchronous command
Automatic measurements