Rohde & Schwarz RTE - Page 1537

Remote control commands
R&S
®
RTE
1537User Manual 1326.1032.02 ─ 20
TRIGger<m>:LIN:ERRPattern <ErrorPattern>
Sets the frame identifier to trigger on a checksum error with TRIGger<m>:LIN:
CHKSerror on page 1536.
Parameters:
<ErrorPattern> Numeric or string pattern, see Chapter 18.4.6, "Bit pattern
parameter", on page 1076.
Possible values depend on TRIGger<m>:LIN:CRCDatalen.
Defining don't care bits 'X' in the ERRP bit string resets CRCDa-
talen to 0. When CRCDatalen is different than 0, then all the bits
in ERRP must be 1 or 0, and X bits are set to 0.
Example:
FORM:BPAT STRG
TRIG1:LIN:ERRP '1X0'
TRIG1:LIN:ERRP?
<-- 1X0XXX
TRIGger:LIN:CRCDatalen?
<-- 0
TRIGger:LIN:CRCDatalen 4
TRIG1:LIN:ERRP?
<-- 100000
TRIG1:LIN:ERRP '00x11'
TRIG1:LIN:ERRP?
<-- 00X11X
TRIGger:LIN:CRCDatalen?
<-- 0
TRIGger<m>:LIN:CRCDatalen <CRCDataLength>
Sets the number of data bytes to trigger on CRC errors (TRIGger<m>:LIN:TYPE is
set to ERRC and TRIGger<m>:LIN:CHKSerror is set ON.)
Parameters:
<CRCDataLength> Values ≠0 restrict allowed bit values in TRIGger<m>:LIN:
ERRPattern to 0 and 1.
Range: 0 to 8
Increment: 1
*RST: 0
TRIGger<m>:LIN:STANdard <LINStandard>
Sets the LIN standard to trigger on CRC errors (TRIGger<m>:LIN:TYPE is set to
ERRC and TRIGger<m>:LIN:CHKSerror is set ON.)
See also: "LIN standard" on page 602.
Parameters:
<LINStandard> V1X | V2X | J2602 | AUTO
*RST: AUTO
Protocols