Rohde & Schwarz RTE - Page 151

Instrument setup
R&S
®
RTE
151User Manual 1326.1032.02 ─ 20
Make sure that the correct waveform tab is selected before you enter the labels.
Source.........................................................................................................................151
Font size......................................................................................................................151
Labels..........................................................................................................................151
Show labels.................................................................................................................152
Position mode............................................................................................................. 152
Source
Selects the waveform to which the label belongs.
Font size
Defines the size of the labels in the diagram.
Remote command:
DISPlay:SIGNal:LABel:FONTsize on page 1105
Labels
For each waveform, the "Labels" table shows the assigned texts and their positions.
Enter the label text and the horizontal and vertical positions for each label.
"Add"
Adds a line at the end of the list.
"Copy"
Copies the selected line in a new line.
"Remove"
Deletes the selected line. Only single lines can be removed.
You can also delete a label by using the toolbar: Tap the "Delete" icon
and then the label.
Remote command:
DISPlay:SIGNal:LABel:ADD on page 1102
DISPlay:SIGNal:LABel:REMove on page 1103
DISPlay:SIGNal:LABel:TEXT on page 1103
DISPlay:SIGNal:LABel:HORizontal:ABSolute:POSition on page 1104
DISPlay:SIGNal:LABel:VERTical:ABSolute:POSition on page 1104
Display configuration