Rohde & Schwarz RTE - Page 1103

Remote control commands
R&S
®
RTE
1103User Manual 1326.1032.02 ─ 20
<YPositon> Vertical position of the label text. Values, range and unit depend
on the position mode, the waveform position and scaling. For
relative position mode, the range is 0 to 100 %.
Example:
DISPlay:SIGNal:LABel:ADD 'Label1', C1W1, 'Label
on C1', REL, 20, 20
Adds the label text 'Label on C1' to the channel1 waveform at
relative position 20% from the upper left corner of the screen.
The label ID is 'Label1'.
Example:
DISPlay:SIGNal:LABel:ADD 'Label2', C2W1, 'Label
on C2', ABS, 10e-09, 0.1
Adds the label text 'Label on C2' to the channel2 waveform at
absolute position 10 ns and 0.1 V. The label ID is 'Label2'.
Usage: Setting only
Asynchronous command
DISPlay:SIGNal:LABel:REMove <LabelID>, <Source>
Deletes the specifies waveform label.
Setting parameters:
<LabelID> String with the label identifier.
<Source> All waveforms that can be displayed, see DISPlay:SIGNal:
LABel:ADD
Example:
DISPlay:SIGNal:LABel:REMove 'Label1', C1W1
Usage: Setting only
Asynchronous command
DISPlay:SIGNal:LABel:TEXT <LabelID>, <Source>, <LabelText>
DISPlay:SIGNal:LABel:TEXT? <LabelID>, <Source>
Modifies or queries the text of the specified label.
Parameters:
<LabelText> String with the label text that is shown
Parameters for setting and query:
<LabelID> String with the label identifier.
<Source> All waveforms that can be displayed, see DISPlay:SIGNal:
LABel:ADD
Usage: Asynchronous command
Instrument setup