Rohde & Schwarz RTE - Page 1095

Remote control commands
R&S
®
RTE
1095User Manual 1326.1032.02 ─ 20
HORizontal
Besides the existing diagram
VERTical
Above or below the existing diagram
TAB
In a new tab in the existing diagram
<InsertBefore> ON | OFF
If on, the new diagram is inserted to the left (for HORizontal),
above (for VERTical) or in a tab in front the existing diagram.
HOR, ON = left to the existing diagram, defined in <NodeName>
HOR, OFF = right to the existing diagram
VERT, ON = above the existing diagram
VERT, OFF = below the existing diagram
<FirstSource> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4 | XY1 | XY2 | XY3 | XY4 |
MRESult1 | MRESult2 | MRESult3 | MRESult4 | MRESult5 |
MRESult6 | MRESult7 | MRESult8 | SBUS1 | SBUS2 | SBUS3 |
SBUS4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7 | D8 | D9 | D10 |
D11 | D12 | D13 | D14 | D15 | MSOB1 | MSOB2 | MSOB3 |
MSOB4 | TRK1 | TRK2 | TRK3 | TRK4 | TRK5 | TRK6 | TRK7 |
TRK8 | Z1V1 | Z1V2 | Z1V3 | Z1V4 | Z1I1 | Z1I2 | Z1I3 | Z1I4 |
Z2V1 | Z2V2 | Z2V3 | Z2V4 | Z2I1 | Z2I2 | Z2I3 | Z2I4 | DIFF1 |
DIFF2 | COMMON1 | COMMON2
Waveform to be displayed in the new diagram, see Chap-
ter 18.4.2, "Waveform parameter", on page 1074.
Spectrum Analysis, option R&S RTE-K18: Spectrograms and
timeline spectrums are automatically displayed in their own dia-
grams.
<DiagramName>
String with the name of the new diagram.
Example:
LAYout:ADD 'Diagram2',TAB,ON,C4W1,'MyDiagram3'
Creates a new diagram 'MyDiagram3' with waveform C4W1 in a
new tab that in front of 'Diagram2'.
Example: See Chapter 18.3.1.1, "Creating diagrams (SmartGrid)",
on page 1055.
Usage: Setting only
Asynchronous command
LAYout:REMove <DiagramName>
Closes the specified diagram. The waveforms are displayed as minimized waveforms
in their signal icons on the signal bar.
Setting parameters:
<DiagramName> String with the name of the diagram
Instrument setup