Rohde & Schwarz RTE - Page 1633

Remote control commands
R&S
®
RTE
1633User Manual 1326.1032.02 ─ 20
BUS<m>:ARINc:SOURce <SourceData>
Sets the channel for the signal source.
Reference and math waveforms are only available if the trigger source is one of the
input channels but not the serial bus.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<SourceData> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4
*RST: C1W1
BUS<m>:ARINc:BRValue
<BitRateValue>
Sets the number of transmitted bits per second.
Suffix:
<m>
.
1..4
Parameters:
<BitRateValue> Range: 10000 to 110000
Increment: 100
*RST: 100000
Default unit: bps
BUS<m>:ARINc:BRMode <BitRateMode>
Sets the bit rate mode to high or low speed.
Suffix:
<m>
.
1..4
Parameters:
<BitRateMode> HIGH | LOW
*RST: HIGH
BUS<m>:ARINc:MAXGap:SELect <MaxGapSelect>
Enables the detection of the maximum gap time during decoding.
To specify the minimum gap time BUS<m>:ARINc:MINGap:BITS.
Suffix:
<m>
.
1..4
Parameters:
<MaxGapSelect> ON | OFF
*RST: OFF
Protocols