Rohde & Schwarz RTE - Page 1209

Remote control commands
R&S
®
RTE
1209User Manual 1326.1032.02 ─ 20
Suffix:
<m>
.
1..3
The suffix is irrelevant.
Parameters:
<Beep> NOACtion | TRIGger
*RST: NOACtion
Usage: Asynchronous command
TRIGger<m>:EVENt:PRINt
<Print>
Saves a screenshot at each trigger if the command is set to TRIGger.
For screenshot settings, see Chapter 18.16.10, "Screenshots", on page 1412.
Suffix:
<m>
.
1..3
The suffix is irrelevant.
Parameters:
<Print> NOACtion | TRIGger
*RST: NOACtion
Usage: Asynchronous command
TRIGger<m>:EVENt:WFMSave <SaveWfm>
Saves the waveform data to file at each trigger if the command is set to TRIGger.
For data export settings, see Chapter 18.16.5, "Waveform data export to file",
on page 1399.
Suffix:
<m>
.
1..3
The suffix is irrelevant.
Parameters:
<SaveWfm> NOACtion | TRIGger
*RST: NOACtion
Usage: Asynchronous command
TRIGger<m>:EVENt:RUNexec <RunExecutable>
Starts an external application if the command is set to TRIGger.
Use the following commands to set up the application:
●
EXECutable:NAME on page 1106
●
EXECutable:PARameter on page 1106
●
EXECutable:WDIRectory on page 1106
Trigger