Getting started
R&S
®
RTE
90User Manual 1326.1032.02 ─ 20
4.
Tap the icon to open the "Measurements" dialog box.
5. Select the "Quick Meas" "Setup".
6. Scroll down in the table and disable the Mean and RMS measurements.
7. Tap "Activate" and select Period.
Now the result box also shows the result of the period measurement.
8. Tap "Activate" and select Frequency.
Now the result box also shows the result of the time measurements.
9. Tap "Set as QuickMeas".
The current configuration is set as default quick measurement and can be repeated
until you save another configuration.
10. Close the dialog box.
11.
To save space in the display, minimize the result box:
The most important results are displayed and updated in the result icon.
Do not close the result icon, as you need the results for the Search example (see
Chapter 3.3.9, "Performing a search", on page 96).
Trying out the instrument
To Next Page
Loading...
