Rohde & Schwarz RTE - Page 491

Data and file management
R&S
®
RTE
491User Manual 1326.1032.02 ─ 20
Histogram to export
Selects the histogram to be exported. All active waveform histograms are shown in the
list.
Measurement histograms can also be exported, see Chapter 12.2.5, "Result analysis",
on page 493.
Remote command:
EXPort:HISTogram:SELect on page 1407
Incidence
Sets the mode of exported histogram data: relative or absolute count of values. If rela-
tive values are exported, the sum of all values is 1, and the count of each value is set
in relation to the sum.
Remote command:
EXPort:HISTogram:INCidence on page 1408
Save to file
Enter the filename to save the waveform histogram to. Double-tap the filename to open
the file selection dialog box.
By default, the filename has the prefix "Histogram_". You can define a pattern for auto-
matic naming in the "Autonaming" tab. The default directory is:
C:\Users\Public\Documents\Rohde-Schwarz\RTE\Histograms
"Save"
Saves the histogram data in the selected file.
"Save As..."
Opens the file selection dialog box and saves the histogram data to
the selected file. See also Chapter 12.7, "File selection dialog",
on page 511
".bin/.xml/.csv"
Selects the file format.
Waveform data and results