Rohde & Schwarz RTE - Page 383

Measurements
R&S
®
RTE
383User Manual 1326.1032.02 ─ 20
●
Gate areas: restricting the waveform range for measurement can eliminate irregu-
lar data, see Chapter 8.2.3, "Measurement gates", on page 341.
●
Spectrum measurements: you can eliminate noise from the evaluation, see
Threshold and "Peak excursion" on page 332
► To enable statistics, use one of the following ways:
● On the "Meas" > "Overview" tab, "Enable" statistics.
● On the "Meas" > "Result Analysis" tab, "Enable" statistics.
If statistics are enabled, the following results are calculated. You can select which
results are shown in the result table, see Chapter 8.2.2.3, "Display settings for results",
on page 340.
Label Description
+Peak Positive peak value (maximum)
-Peak Negative peak value (minimum)
μ (Avg) Average
RMS Root mean square
σ (S-dev) Standard deviation
Event count Number of measured events (e.g. rising edges, pulses etc.)
Wave count Number of waveforms (acquisitions) the measurement is based on
Remote commands:
●
MEASurement<m>:RESult[:ACTual]? on page 1255
●
MEASurement<m>:RESult:AVG? on page 1255
●
MEASurement<m>:RESult:COUNt? on page 1256
●
MEASurement<m>:RESult:EVTCount? on page 1255
●
MEASurement<m>:RESult:NPEak? on page 1255
●
MEASurement<m>:RESult:PPEak? on page 1255
●
MEASurement<m>:RESult:RMS? on page 1255
●
MEASurement<m>:RESult:STDDev? on page 1255
●
MEASurement<m>:RESult:WFMCount? on page 1255
●
MEASurement<m>:RESult:STARt? on page 1256
●
MEASurement<m>:RESult:STOP? on page 1256
●
MEASurement<m>:ARNames on page 1255
●
MEASurement<m>:ARES? on page 1254
The peak and average values and the standard deviation of the long-term points are
also shown in the graph of the long-term measurement.
Automatic measurements