Rohde & Schwarz RTE - Page 1421

Remote control commands
R&S
®
RTE
1421User Manual 1326.1032.02 ─ 20
BUS<m>:SETReflevels
Executes the measurement of reference levels and sets the thresholds to the middle
reference level of the measured amplitude.
Suffix:
<m>
.
1..4
Selects the serial bus.
Usage: Event
Asynchronous command
BUS<m>:FAUToset
Starts software algorithms for determining the signal threshold levels and bitrate.
Suffix:
<m>
.
1..4
Usage: Event
Asynchronous command
BUS<m>:LABel <LabelObsolete>
Defines a label to be displayed with the bus.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<LabelObsolete> String containing the label text.
Usage: Asynchronous command
BUS<m>:RESult <ShowResultTable>
Opens a table with decoded data of the serial signal. The function affects all protocol
types and requires the option for the analyzed protocol.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<ShowResultTable> ON | OFF
*RST: ON
Usage: Asynchronous command
BUS<m>:THReshold <ShwThresLines>
If ON, the threshold levels are displayed in the diagram.
Protocols