Rohde & Schwarz RTE - Page 1380

Remote control commands
R&S
®
RTE
1380User Manual 1326.1032.02 ─ 20
Usage: Asynchronous command
SEARch:GATE:SHOW <SearchName>,<DisplayState>
SEARch:GATE:SHOW? <SearchName>
If enabled, the gate area is indicated in the source diagram.
Parameters:
<DisplayState> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
SEARch:GATE:ABSolute:STARt <SearchName>,<Start>
SEARch:GATE:ABSolute:STARt? <SearchName>
Defines the starting value for the gate.
Parameters:
<Start> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
SEARch:GATE:ABSolute:STOP <SearchName>,<Stop>
SEARch:GATE:ABSolute:STOP? <SearchName>
Defines the end value for the gate.
Parameters:
<Stop> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0.01
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
SEARch:GATE:RELative:STARt <SearchName>,<RelativeStart>
SEARch:GATE:RELative:STARt? <SearchName>
Defines the starting value for the gate.
Search