Remote control commands
R&S
®
RTE
1099User Manual 1326.1032.02 ─ 20
DISPlay:DIAGram:YFIXed <YGridFixed>
If enabled, the horizontal grid lines remain in their position when the position of the
curve is changed. Only the values at the grid lines are adapted. This reflects the
behavior of traditional oscilloscopes.
Parameters:
<YGridFixed> ON | OFF
Usage: Asynchronous command
DISPlay:DIAGram:XFIXed
<XGridFixed>
If enabled, the vertical grid lines remain in their position when the horizontal position is
changed. Only the values at the grid lines are adapted.
Parameters:
<XGridFixed> ON | OFF
*RST: OFF
Usage: Asynchronous command
DISPlay:GATE:TRANsparency <Transparency>
Sets the transparency of the area that is defined as measurement or search gate.
Parameters:
<Transparency> Range: 0 to 100
Increment: 1
*RST: 43
Default unit: %
Usage: Asynchronous command
Firmware/software: FW 3.20
DISPlay:RESultboxes:DEFaultpos <State>
Defines where a new result box opens.
Parameters:
<State> PREV | FLOA
PREV
Preview: The result box opens as a minimized result icon on the
signal bar. It shows only two colums and a few rows of the
results.
FLOA
Floating: The result box opens as a box similar to a dialog box in
front of the diagrams. It can be moved and shows all results.
Usage: Asynchronous command
Instrument setup
To Next Page
Loading...
