Remote control commands
R&S
®
RTE
1253User Manual 1326.1032.02 ─ 20
Usage: Asynchronous command
MEASurement<m>:MAIN <MeasType>
Defines the measurement type of the indicated measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<MeasType> Amplitude/time measurements
HIGH | LOW | AMPLitude | MAXimum | MINimum | PDELta |
MEAN | RMS | STDDev | POVershoot | NOVershoot | AREA |
RTIMe | FTIMe | PPULse | NPULse | PERiod | FREQuency |
PDCYcle | NDCYcle | CYCarea | CYCMean | CYCRms |
CYCStddev | PULCnt | DELay | PHASe | BWIDth | PSWitching |
NSWitching | PULSetrain | EDGecount | SHT | SHR | DTOTrig-
ger | PROBemeter | SLERising | SLEFalling
See Chapter 18.12.3, "Amplitude/time measurements",
on page 1257.
*RST value for amplitude/time measurements: AMPLitude.
Eye diagram measurements
ERPercent | ERDB | EHEight | EWIDth | ETOP | EBASe | QFAC-
tor | RMSNoise | SNRatio | DCDistortion | ERTime | EFTime |
EBRate | EAMPlitude | PPJitter | STDJitter | RMSJitter
See Chapter 18.12.4, "Eye diagram measurements",
on page 1266
*RST value for eye/jitter measurements: ERPercent.
Spectrum measurements
CPOWer | OBWidth | SBWidth | THD | THDPCT | THDA | THDU
| THDR | PLISt | HAR | THDF
See Chapter 18.12.5, "Spectrum", on page 1269.
*RST value for spectrum measurements: CPOWer.
Histogram measurements
WCOunt | WSAMples | HSAMples | HPEak | PEAK | UPEak-
value | LPEakvalue | HMAXimum | HMINimum | MEDian | MAX-
Min | HMEan | HSTDdev | M1STddev | M2STddev | M3STddev |
MKPositive | MKNegative
See Chapter 18.12.6.2, "Histogram measurement",
on page 1283.
*RST value for histogram measurements: WCOunt.
Protocol measurements
NONE | AUDio | F2F | F2A | FLDValue | GAP | MBITrate | SBI-
Trate | BIDLe | FCNT | FEC | FER | CFER
Requires option R&S RTE-K35
See Chapter 18.12.9, "Protocol", on page 1295
Automatic measurements
To Next Page
Loading...
