Rohde & Schwarz RTE - Page 1912

Remote control commands
R&S
®
RTE
1912User Manual 1326.1032.02 ─ 20
Suffix:
<m>
.
1..3
1 = A-trigger, 2 = B-trigger, 3 = R-trigger
Available values depend on the selected trigger source. For
input channels CHAN1...4, a trigger sequence can be config-
ured.
For all other trigger sources, only suffix 1 is allowed.
Parameters:
<SourceDetailed> CHAN1 | CHANnel1 | CHAN2 | CHANnel2 | CHAN3 |
CHANnel3 | CHAN4 | CHANnel4 | EXTernanalog | SBUS | D0 |
D1 | D2 | D3 | D4 | D5 | D6 | D7 | D8 | D9 | D10 | D11 | D12 |
D13 | D14 | D15 | LOGIC | MSOB1 | MSOB2 | MSOB3 |
MSOB4 | Z1V1 | Z1V2 | Z1V3 | Z1V4 | Z1I1 | Z1I2 | Z1I3 | Z1I4 |
Z2V1 | Z2V2 | Z2V3 | Z2V4 | Z2I1 | Z2I2 | Z2I3 | Z2I4 | DIFF1 |
DIFF2 | COMMON1 | COMMON2 | LINE
CHAN1 = CHANnel1, CHAN2 = CHANnel2, CHAN3 = CHAN-
nel3, CHAN4 = CHANnel4
Input channels
EXTernanalog
External analog signal connected to the External Trigger Input.
For this source, only the analog edge trigger is available.
LINE
The instrument generates the trigger from the AC power input
and synchronizes the signal to the AC power frequency.
SBUS
Serial bus
D0...D15
Digital channels (option R&S RTE-B1)
See also: Chapter 18.18.4, "Trigger settings for digital signals
and parallel buses", on page 1911
LOGIc
Logic combination of digital channels, used as trigger source
(option R&S RTE-B1)
MSOB1 | MSOB2 | MSOB3 | MSOB4
Parallel bus (option R&S RTE-B1)
Z1V1 | Z1V2 | Z1V3 | Z1V4 | Z1I1 | Z1I2 | Z1I3 | Z1I4 | Z2V1 |
Z2V2 | Z2V3 | Z2V4 | Z2I1 | Z2I2 | Z2I3 | Z2I4
Input channels of R&S RT-ZVCmulti-channel power probe. Only
available in the A-trigger with trigger type EDGE.
DIFF1 | DIFF2 | COMMON1 | COMMON2
Differential signals
*RST:
CHAN1
Usage: Asynchronous command
Mixed signal option (MSO, R&S RTE-B1)