Rohde & Schwarz RTE - Page 439

Mask testing
R&S
®
RTE
439User Manual 1326.1032.02 ─ 20
To move a point on the touch screen
1. Tap the mask segment that you want to change.
2. Drag&drop the point to the new position.
3. Tap outside the mask to deselect the mask segment.
To change the mask definition numerically
The settings mentioned here are described in detail in Chapter 10.2.2.1, "Mask defini-
tion: user mask", on page 426.
1. Press the [MASKS] key on the front panel.
2. Select the "Mask Definition" tab.
3. On the left, select the mask test for which you want to change the mask definition.
4. To add or delete a mask segment, tap the segment's row in the "Mask segments"
table and tap the required button below:
● "Insert": to add a new segment before the selected segment.
● "Append": to add a new segment at the end of the list.
● "Remove": to delete the selected mask segment from the list.
5. To add, delete, or move a point of a segment:
a) Select the segment in the "Mask segments" table.
b) Select the point in the "Definition of segment" table.
c) To add or delete the selected point, use the buttons below the table.
● "Insert": to add a new point before the selected point.
● "Append": to add a new point at the end of the list.
● "Remove": to delete the selected point from the list.
Working with masks