Getting started
R&S
®
RTE
71User Manual 1326.1032.02 ─ 20
In the "Cursors" dialog box, you can:
●
Configure up to 2 cursor sets
●
Define style and labels of the cursors
●
Connect the cursor to the waveform and couple the cursors
[MEAS]
Starts the default automatic measurement for the active waveform and opens the
"Measurement" result box.
If you press the [MEAS] key while a measurement is enabled, the "Measurements" dia-
log box is displayed, where you can:
●
Configure amplitude and time measurements, eye, spectrum, and histogram mea-
surements
●
Configure gated measurement
●
Configure long term and statistic measurements
[ZOOM]
Displays a zoom diagram for the active diagram. The key is illuminated if at least one
zoom is active. If you press the key while the zoom function is on, the "Zoom" dialog
box opens, where you can configure several zoom areas for detailed signal observa-
tion.
[PROTOCOL]
Opens the "Protocol" dialog box which contains the configuration of serial buses and
the settings for decoding the signals.
The key lights up if the decoding of a serial bus is active. You can switch off the deco-
ded bus using the [SIGNAL OFF] key.
[SEARCH]
Opens and closes the "Search" dialog box, where you can:
●
Configure trigger events to be searched for
●
Limit the search by gating
●
Configure the presentation of search results
[MASKS]
Opens and closes the "Masks" dialog box. Masks are used for error detection and
compliance tests of digital signals.
You can:
●
Configure masks and masks segments
●
Define mask test parameters
●
Configure actions triggered by mask violation
●
Configure the mask display
[LOGIC]
Opens the dialog box for configuration of parallel buses and digital channels. The key
lights up if you enable at least one parallel bus. You can switch off the selected bus
using the [SIGNAL OFF] key.
Instrument tour
To Next Page
Loading...
