Rohde & Schwarz RTE - Page 750

Protocol analysis
R&S
®
RTE
750User Manual 1326.1032.02 ─ 20
<sb:FRAME NAME="SENT Standard Revision" STATE="ON">
<sb:SHORT-NAME>SENT Standard</sb:SHORT-NAME>
<sb:DESCRIPTION>specifies the SENT Standard Revision Number</sb:DESCRIPTION>
<sb:ID-VALUE>10</sb:ID-VALUE>
<sb:ID-LENGTH>4</sb:ID-LENGTH>
<sb:DATA-SIZE>8</sb:DATA-SIZE>
<sb:SIGNALS>
<sb:SIGNAL ID="Revision">
<sb:SHORT-NAME>Revision</sb:SHORT-NAME>
<sb:DESCRIPTION>SENT-Standard Revision Number</sb:DESCRIPTION>
<sb:BIT-POSITION>7</sb:BIT-POSITION>
<sb:BIT-LENGTH>8</sb:BIT-LENGTH>
<sb:BYTE-ORDER>MSB</sb:BYTE-ORDER>
<sb:VALUE-TYPE>ENUM</sb:VALUE-TYPE>
<sb:FACTOR>1.0</sb:FACTOR>
<sb:OFFSET>0.0</sb:OFFSET>
<sb:MIN>0</sb:MIN>
<sb:MAX>4.0</sb:MAX>
<sb:ENUM-VALUES>
<sb:ENUM INDEX="0" LABEL="Not defined"/>
<sb:ENUM INDEX="1" LABEL="J2716 Rev 1"/>
<sb:ENUM INDEX="2" LABEL="J2716 Rev 2"/>
<sb:ENUM INDEX="3" LABEL="J2716 Rev 3"/>
</sb:ENUM-VALUES>
</sb:SIGNAL>
</sb:SIGNALS>
</sb:FRAME>
<sb:FRAME NAME="Diagnostic Error Codes" STATE="ON">
<sb:DESCRIPTION>used to diagnose the current SENT System</sb:DESCRIPTION>
<sb:ID-VALUE>01</sb:ID-VALUE>
<sb:ID-LENGTH>8</sb:ID-LENGTH>
<sb:DATA-SIZE>12</sb:DATA-SIZE>
<sb:SIGNALS>
<sb:SIGNAL ID="Diagnostic">
<sb:SHORT-NAME>Diagnostic Code</sb:SHORT-NAME>
<sb:DESCRIPTION></sb:DESCRIPTION>
<sb:BIT-POSITION>11</sb:BIT-POSITION>
<sb:BIT-LENGTH>12</sb:BIT-LENGTH>
<sb:BYTE-ORDER>MSB</sb:BYTE-ORDER>
<sb:VALUE-TYPE>ENUM</sb:VALUE-TYPE>
<sb:FACTOR>1.0</sb:FACTOR>
<sb:OFFSET>0.0</sb:OFFSET>
<sb:MIN>0</sb:MIN>
<sb:MAX>4096</sb:MAX>
<sb:ENUM-VALUES>
<sb:ENUM INDEX="0" LABEL="No Error"/>
<sb:ENUM INDEX="1" LABEL="Channel 1 out of range high"/>
<sb:ENUM INDEX="2" LABEL="Channel 1 out of range low"/>
<sb:ENUM INDEX="3" LABEL="Initialization Error (Channel 1)"/>
<sb:ENUM INDEX="4" LABEL="Channel 2 out of range high"/>
SENT (option R&S
RTE-K10)