Rohde & Schwarz RTE - Page 886

Protocol analysis
R&S
®
RTE
886User Manual 1326.1032.02 ─ 20
See: "Frame ID" on page 887
●
Set an NM value expected in the frame.
See "NM" on page 889.
●
Set a CT value expected in the frame.
See: "CT" on page 889.
●
Set a DLC extend pattern or DLC extend pattern range to trigger only on frames
that fulfill these conditions.
See: "DLC Extend" on page 888.
●
Set a data pattern condition to trigger only on frames that fulfill these conditions.
See: "Data" on page 888.
●
Set an index or index range to trigger only on frames that fulfill these conditions.
See: "Index" on page 889.
PID ← Trigger type
Triggers on a protected ID (PID) field. A PID field consists of a frame identifier and a
parity bit.
Optionally, you can define the frame ID pattern or a frame ID range to trigger only on
frames that fulfill these conditions.
See:"Frame ID" on page 887.
PTYPE ← Trigger type
Triggers on a protected TYPE (PTYPE) field, a special PID field with a frame ID of 00
(hex) and a parity of 1. It is used only in the polling method.
PTYPE + PID ← Trigger type
Triggers on a PTYPE field followed by a PID field.
CXPI (option R&S
RTE-K76)