Waveform generator (Option R&S RTE-B6)
R&S
®
RTE
944User Manual 1326.1032.02 ─ 20
Using pattern generator accessories
The pattern generator with connected Patt Gen Cable and Patt Gen Board
(1329.7054.02) is considered as a test probe, EN 61326-2-1, clause 5.2.4.101, note 1.
Therefore normal operation may display increased emissions above the limits as speci-
fied in EN 55011 and/or reduced interference resistance as required in EN 61326-1,
table 1, basic requirements.
If the cable and the board are connected, other surrounding electronic devices may be
disturbed. Furthermore, signals at the analog generator outputs Gen1 and Gen2 may
be distorted by surrounding devices.
Setup of the pattern generator
To Next Page
Loading...
