Rohde & Schwarz RTE - Page 1501

Remote control commands
R&S
®
RTE
1501User Manual 1326.1032.02 ─ 20
BUS<m>:CAN:FRAMe<n>:DLCState?........................................................................... 1504
BUS<m>:CAN:FRAMe<n>:IDSTate?..............................................................................1504
BUS<m>:CAN:FRAMe<n>:ACKValue?.......................................................................... 1505
BUS<m>:CAN:FRAMe<n>:BITRate?............................................................................. 1505
BUS<m>:CAN:FRAMe<n>:CSValue?.............................................................................1505
BUS<m>:CAN:FRAMe<n>:DLCValue?...........................................................................1506
BUS<m>:CAN:FRAMe<n>:IDTYpe?.............................................................................. 1506
BUS<m>:CAN:FRAMe<n>:IDValue?..............................................................................1507
BUS<m>:CAN:FRAMe<n>:BSEPosition?....................................................................... 1507
BUS<m>:CAN:FRAMe<n>:FERCause?......................................................................... 1507
BUS<m>:CAN:FRAMe<n>:SDEXport?...........................................................................1508
BUS<m>:CAN:FDATa:FRAMe<n>:SCValue?.................................................................. 1508
BUS<m>:CAN:FRAMe<n>:BYTE<o>:STATe?.................................................................1508
BUS<m>:CAN:FRAMe<n>:BYTE<o>:VALue?.................................................................1509
BUS<m>:CAN:FCOunt?
Returns the number of decoded frames of the acquisition.
Suffix:
<m>
.
1..4
Selects the serial bus.
Return values:
<Count> Total number of decoded frames.
Range: 0 to 100000
Increment: 1
*RST: 0
Usage: Query only
BUS<m>:CAN:FDATa:FRAMe<n>:STANdard?
Returns the CAN standard.
The setting is available in CAN FD option R&S RTE-K9.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
The frame suffix is irrelevant.
Return values:
<Standard> CAN | CANFd
*RST: CAN
Usage: Query only
Protocols