Rohde & Schwarz RTE - Page 1570

Remote control commands
R&S
®
RTE
1570User Manual 1326.1032.02 ─ 20
CASMts
Collision Avoidance Symbol / Media access Test Symbol. These
symbols are identical and can be sent in the optional symbol
window at the end of a communication cycle. They are used to
avoid collisions during the system start.
WAKeup
The wakeup pattern is sent to activate the nodes of the system.
*RST: CASMts
TRIGger<m>:FLXRay:BSSerror
<BSSError>
Triggers on error in SyteStart Sequence. The BSS is transmitted before each byte.
Parameters:
<BSSError> ON | OFF
*RST: ON
TRIGger<m>:FLXRay:FESerror <FESError>
Triggers on error in Frame End Sequence. FES indicates the end of each frame.
Parameters:
<FESError> ON | OFF
*RST: ON
TRIGger<m>:FLXRay:FSSerror <FSSError>
Triggers on Error in a Frame Start Sequence. FSS follows the Transmission Start
Sequence TSS at the beginning of each frame.
Parameters:
<FSSError> ON | OFF
*RST: ON
TRIGger<m>:FLXRay:HCRCerror <CRCHeaderError>
Triggers on error in the Cyclic Redundancy Check of the header data (mainly frame ID
and payload length).
Parameters:
<CRCHeaderError> ON | OFF
*RST: ON
TRIGger<m>:FLXRay:PCRCerror <CRCPayloadError>
Triggers on error in the Cyclic Redundancy Check of the payload data.
Protocols