Rohde & Schwarz RTE - Page 1624

Remote control commands
R&S
®
RTE
1624User Manual 1326.1032.02 ─ 20
SEARch:TRIGger:MILStd:TYPE <SearchName>,<Type>
SEARch:TRIGger:MILStd:TYPE? <SearchName>
Sets the event to be searched for.
Parameters:
<Type> STYPe | WTYPe | DATA | CDST | CMD | STATword | ERR
See TRIGger<m>:MILStd:TYPE on page 1610
*RST: STYPe
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:MILStd:DATA:RCONdition
<SearchName>,<RTAOperator>
SEARch:TRIGger:MILStd:DATA:RCONdition? <SearchName>
SEARch:TRIGger:MILStd:CMD:RCONdition <SearchName>,<RTAOperator>
SEARch:TRIGger:MILStd:CMD:RCONdition? <SearchName>
SEARch:TRIGger:MILStd:CDST:RCONdition <SearchName>,<RTAOperator>
SEARch:TRIGger:MILStd:CDST:RCONdition? <SearchName>
Set the operator to define a remote terminal address:
●
DATA: for data words
●
CMD: for command words
●
CDST: for status words
Parameters:
<RTAOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one pattern to
be set with SEARch:TRIGger:MILStd:CDST:RMIN.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with SEARch:TRIGger:MILStd:CDST:RMIN and
SEARch:TRIGger:MILStd:CDST:RMAX on page 1625.
*RST: EQUal
Parameters for setting and query:
<SearchName> String parameter
Protocols