Rohde & Schwarz RTE - Page 1770

Remote control commands
R&S
®
RTE
1770User Manual 1326.1032.02 ─ 20
SEARch:RESult:CMSB<m>:FRAMe<n>:CTHRee?..........................................................1773
SEARch:RESult:CMSB<m>:FRAMe<n>:CTWO?............................................................ 1773
SEARch:RESult:CMSB<m>:FRAMe<n>:STARt?.............................................................1774
SEARch:RESult:CMSB<m>:FRAMe<n>:STATe?.............................................................1774
SEARch:RESult:CMSB<m>:FRAMe<n>:STOP?............................................................. 1775
SEARch:RESult:CMSB<m>:FRAMe<n>:TYPE?..............................................................1775
SEARch:RESult:CMSB<m>:FCOunt? <SearchName>
Returns the count number of decoded result frames in a custom serial bus waveform.
Basically, this is the maximum result index <n> when querying results by using
SEARch:RESult:CMSB<m>:FRAMe<n>:XXX.
Suffix:
<m>
.
*
Query parameters:
<SearchName>
Return values:
<FrameCount> Range: 0 to 100000
Increment: 1
*RST: 0
Usage: Query only
SEARch:RESult:CMSB<m>:FRAMe<n>:CCOunt? <SearchName>
Returns the count number of cell in the frames, within the search result, in a custom
serial bus waveform.
Suffix:
<m>
.
*
<n> *
Query parameters:
<SearchName>
Return values:
<NumWords> Range: 0 to 4294967295
Increment: 1
*RST: 0
Usage: Query only
SEARch:RESult:CMSB<m>:FRAMe<n>:CELL<o>:NAME? <SearchName>
Returns the name of the specified cell within the search result. Cell names are not nec-
essarily unique.
Suffix:
<m>
.
*
Protocols