Rohde & Schwarz RTE - Page 1933

Remote control commands
R&S
®
RTE
1933User Manual 1326.1032.02 ─ 20
WGENerator<m>:ARBGen:NAME................................................................................. 1934
WGENerator<m>:ARBGen:OPEN................................................................................. 1934
WGENerator<m>:ARBGen:RUNMode............................................................................1934
WGENerator<m>:ARBGen:SAMPles?............................................................................1935
WGENerator<m>:ARBGen:SELect................................................................................ 1935
WGENerator<m>:ARBGen:SRATe.................................................................................1935
WGENerator<m>:ARBGen[:SOURce]............................................................................ 1935
WGENerator<m>:ARBGen:COPY
Loads the waveform from the selected signal source (WGENerator<m>:ARBGen:
SELect).
Suffix:
<m>
.
1..2
Usage: Event
Asynchronous command
WGENerator<m>:ARBGen:MULTichannel:IMPort <SavedWfmSrc>
Assigns a waveform from the multichannel file to the arbitrary waveform generator.
Suffix:
<m>
.
1..2
Parameters:
<SavedWfmSrc> WFM1 | WFM2 | WFM3 | WFM4
*RST: WFM1
Example:
WGENerator1:ARBGen:MULTichannel:NAME
ArbMultichannelCurve_2017-02-16_01.bin
WGENerator1:ARBGen:MULTichannel:IMPort WF1
WGENerator1:ARBGen:MULTichannel:OPEN
WGENerator<m>:ARBGen:MULTichannel:NAME <FilePath>
Defines the path and the multichannel arbitrary waveform file to be imported. If not
path is given, the default path
C:\Users\Public\Public Documents\Rohde-Schwarz\RTx\RefWaveforms
is used.
Suffix:
<m>
.
1..2
Parameters:
<FilePath>
Example: See WGENerator<m>:ARBGen:MULTichannel:IMPort
on page 1933.
Waveform generator (option R&S RTE-B6)