Rohde & Schwarz RTE - Page 520

Protocol analysis
R&S
®
RTE
520User Manual 1326.1032.02 ─ 20
The common settings for all protocols are:
Load from file
Selects and loads a label list file. Available file formats are PTT, CSV, DBC (CAN only),
and XML (FIBEX files, FlexRay only).
Label lists are protocol-specific. Their contents are described in the corresponding pro-
tocol chapters:
●
Chapter 13.2.4, "I
2
C label list", on page 531
●
Chapter 13.5.4, "CAN / CAN FD label list", on page 578
●
Chapter 13.6.4, "LIN label list", on page 608
●
Chapter 13.7.3, "FlexRay label list", on page 627
●
Chapter 13.10.4, "ARINC 429 label list", on page 685
●
Chapter 13.9.4, "MIL-STD-1553 label list", on page 670
Remote command:
BUS<m>:NEWList on page 1422
Clear
Deletes the label list from the instrument.
Apply label list
Activates the label list to be used for decoding. The "Label" appear in the "Decode
results" table and in the frame captions of the decoded signal.
Remote command:
BUS<m>:SYMBols on page 1423
Basics of protocol analysis