Protocol analysis
R&S
®
RTE
583User Manual 1326.1032.02 ─ 20
Table 13-5: Content of the "Decode results" table
Column Description
State Overall state of the frame.
"Insuffcient waveform length" indicates that the frame is not completely contained
in the acquisition. Change the horizontal scale, or move the reference point to the
left to get a longer acquisition.
Start Time of frame start
Type Frame type: Data, Remote, Error, or Overload
ID type 11-bit standard format or 29-bit extended format
ID value (hex) Identifier value, hexadecimal value
Standard Frame format, CAN or CAN FD.
Only available in CAN FD option R&S RTE-K9.
Label Symbolic label name defined in the label list
DLC Data length code, coded number of data bytes
NDB Actual number of data bytes
Values Value of the data frame. The data format is selected below the table. Remote
frames do not transmit data, therefore "- - -" is displayed.
Symbolic data Values of the individual signals that are part of a message. The column is shown
instead of the "Values" column, if a DBC file is loaded and the "Data format" is
"Symbolic".
SC (dec) Stuff count value, decimal value.
Only available for CAN FD ISO signals, option R&S RTE-K9.
CRC (hex) Value of the Cyclic Redundance Check (checksum), hexadecimal value
Form error cause Reason of a form error if a form error occurred
You can also enable "Show details" in the decode table, to display a more detailed
analysis of the selected frame. The details include the data, identifier, the label and the
symbolic name.
CAN and CAN FD (option R&S RTE-K3/K9)
To Next Page
Loading...
