Protocol analysis
R&S
®
RTE
764User Manual 1326.1032.02 ─ 20
Data min ← Serial Message setup
Sets the data pattern. Enter the bytes in msb first bit order. The maximum pattern
length is 64 bit. Waveform data is compared with the pattern byte-by-byte.
Remote command:
SEARch:TRIGger:SENT:SDMN on page 1725
Data max ← Serial Message setup
The second data pattern is required to specify a range with conditions "In range" and
"Out of range".
Remote command:
SEARch:TRIGger:SENT:SDMX on page 1725
Error conditions setup
Performs the search on one or more of the following error events:
●
"Transmission sequence errors"
– "Calibration Pulse Error"
Searches for calibration pulse errors.
– "Pulse Period Error"
Searches for pulse period errors in a transmission sequence.
– "Irregular Frame Length Error"
Searches for irregular frame length errors in a transmission sequence if pause
pulse mode is set to constant frame length..
●
Serial message error
– "Form Error"
Searches for format errors in serial messages.
●
"CRC Error"
Searches for errors in the complete data transmission.
Remote command:
SEARch:TRIGger:SENT:PULSeerror on page 1725
SEARch:TRIGger:SENT:PPERioderror on page 1726
SEARch:TRIGger:SENT:FORMerror on page 1726
SEARch:TRIGger:SENT:CRCerror on page 1726
SEARch:TRIGger:SENT:IRFLength on page 1726
SENT (option R&S
RTE-K10)
To Next Page
Loading...
