TC1796
Peripheral Units (Vol. 2 of 2)
Micro Link Interface (MLI)
User’s Manual 23-50 V2.0, 2007-07
MLI, V2.0
• Not selected output signals are at low level.
The usage of signal BRKOUT is implementation-specific and can be used, for example,
to generate a break condition in the on-chip debug support logic or trigger other
functions. This signal is activated (as a pulse) by a Command Frame.
The service request outputs SR[7:0] of the MLI module can be activated (as a pulse) by
transmitter or receiver events (for all SRx), as well as by Command Frames (only for
SR[3:0]).
To Next Page
Loading...