EasyManuals Logo

Infineon Technologies TC1796 User Manual

Infineon Technologies TC1796
2150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1981 background imageLoading...
Page #1981 background image
TC1796
Peripheral Units (Vol. 2 of 2)
Analog-to-Digital Converter (ADC)
User’s Manual 25-50 V2.0, 2007-07
ADC, V2.0
conversion. The contents of register SYSTAT will be overwritten if a new synchronized
conversion is requested. Status flags indicate the state (master and/or slave) of the ADC
module during the synchronized conversion.
25.1.10.1 Synchronized Injection Mode
The Synchronized Injection Mode is controlled by bit field CHCONn.SYM in the ADC
channel control register n. A synchronized conversion is always initiated by an analog
channel operating in Synchronized Injection Mode instead of a normal request. The
initiating ADC module is named as master, while the participating ADC module is named
as slave.
To initiate a synchronized conversion in both ADC modules, the analog channel
configured for Synchronized Injection Mode must be triggered by any source. If it wins
the arbitration, a synchronized conversion is initiated in both ADC modules. This means
that the control information needed for a synchronized conversion is transferred from the
master to the slave (for instance, analog channel 2 of ADC module 0 is configured for
Synchronized Injection Mode with sync-wait feature selected; then, each time this
channel is triggered and wins the arbitration, a synchronized conversion is requested.
Thus, ADC module 0 is assumed to be the master and the control information needed
for a synchronized conversion is transferred to ADC Module 1 the slave).
Note: A Channel Injection request with an active cancel-inject-repeat feature that is
requesting a Synchronized Injection does not cancel a running conversion in the
master. A Channel Injection request with an active cancel-inject-repeat feature
does not automatically set the cancel-sync-repeat mode in the Synchronized
Injection.
The Synchronized Injection Mode provides two features:
Sync-wait (CHCONn.SYM = 01
B
):
The synchronized start of the conversion is delayed until the currently performed
conversions in the partner (slave) and the initiating ADC module (master) are
terminated.
Cancel-sync-repeat (CHCONn.SYM = 10
B
):
This feature provides the ability to cancel a conversion that is currently performed in
the slave ADC module. Thus, the synchronized conversion is immediately started
after a currently performed conversion in the initiating ADC module is terminated.
Because a conversion is cancelled in the slave ADC module, the control information
is restored and will participate in arbitration again.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Infineon Technologies TC1796 and is the answer not in the manual?

Infineon Technologies TC1796 Specifications

General IconGeneral
BrandInfineon Technologies
ModelTC1796
CategoryController
LanguageEnglish