EasyManuals Logo

Infineon Technologies TC1796 User Manual

Infineon Technologies TC1796
2150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #326 background imageLoading...
Page #326 background image
TC1796
System Units (Vol. 1 of 2)
On-Chip System Buses and Bus Bridges
User’s Manual 6-33 V2.0, 2007-07
Buses, V2.0
greater or equal to SBCU_DBADR1.
ONG = 1 means that the grant debug trigger is enabled.
CONCOM[2:0] = 101
B
means that the address trigger is created by address trigger 1
OR address trigger 2 (CONCOM1 = 0), and that the grant trigger is ANDed with the
address trigger (CONCOM0 = 1), and that the signal status trigger is ANDed with the
address trigger (CONCOM2 = 1).
RA = 1 means that the BCU breakpoint logic is rearmed.
4. Writing SBCU_DBGRNT = FFFFFFF7
H
:
means that the grant trigger for the SPB bus master PCP is enabled.
5. Writing SBCU_DBBOS is “don’t care”. No signal trigger for SVM, WR, or RD is
generated.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Infineon Technologies TC1796 and is the answer not in the manual?

Infineon Technologies TC1796 Specifications

General IconGeneral
BrandInfineon Technologies
ModelTC1796
CategoryController
LanguageEnglish